This incredibly flexible amplifier packs a serious full-range punch and delivers a staggering 100 watts to each of its six channels into 2 ohms (14.4V, 1% THD). The breakthrough that makes this much power possible in such a small chassis is our NexDâ„¢ ultra-high-speed switching design, which allows for full bandwidth Class D operation with extremely low distortion and outstanding efficiency.
With the XD600/6v2, you have lots of great options. Use it as a six-channel satellite amplifier with 75 W x 6 @ 4 Î©, or bridge four of its channels to create a staggered power four-channel amplifier with 200 W x 2 @ 4 Î© for your front satellites and 75 W x 2 @ 4 Î© for your rear satellites. You can also drive two subwoofers with 200 W each, plus a pair of satellites with 75W x 2.
The XD600/6v2 includes a 12 dB / octave filter for each channel bank, which can be configured as a low-pass or high-pass filter and offers continuously variable cutoff frequency selection from 50-500 Hz.
The XD600/6v2 also features the v2 Spec feature set, which consists of automatic turn-on capability (via signal sensing or DC-offset sensing), and a dual-range differential-balanced input section able to handle a wide range of input voltage levels. With the addition of an HD-RLC remote level control (sold separately), the amplifier's level can be directly controlled from the driver's seat.
This amplifier features a black powder-coat finish and a gasketed, brushed aluminum cover for the controls.
|Specificatii||Rated Continuous (RMS) Power @ 14.4 V
@ 4 Î© 75 W RMS x 6
@ 2 Î© 100 W RMS x 6
Bridged @ 4Î© 200 W RMS x 3
Rated Continuous (RMS) Power @ 12.5 V
@ 4 Î© 60 W RMS x 6
@ 2 Î© 90 W RMS x 6
Bridged @ 4Î© 180 W RMS x 3
Frequency Response 12 Hz - 22 kHz (+0, -1dB)
S/N Ratio, referred to highest rated power >104 dB below rated power (A-weighted, 20 Hz - 20 kHz noise bandwidth)
S/N Ratio, referred to 1 W >84 dB (A-weighted, 20 Hz - 20 kHz noise bandwidth)
Damping Factor @ 4 Î© >150 / 50 Hz
Damping Factor @ 2 Î© >75 / 50 Hz
THD+N @ Rated Power <1% @ 2 Î© per Ch.
Input Voltage Range @ RCA Inputs Switchable from 200 mV - 2 V RMS (Low) to 800 mV - 8 V RMS (High)
Min Copper Power / Ground Wire Gauge 4 AWG wire
Fuse Rating 50 A (AFS, AGU or MaxiFuseâ„¢)
Filter Modes Low-Pass or High-Pass
Filter Slope (dB/Octave) 12dB
Filter Frequency Range 50-500 Hz
Detented, Calibrated Filter Freq. Potentiometers Yes
Filter Defeatable? Yes
Remote Level Control Optional (HD-RLC)
Remote Level Modes 2 or 4 or All Channels
Channel Input Mode Switch Yes (2/4/6 ch.)
Pass-Through Preamp Output Type None
Source Channel Selection for PreOuts N/A